About Us Rope Products How Its Made Contact Us

Endura 12 Strand 100% Dyneema

Product Description:
Endura 12 is manufactured from 100% HMPE fiber. The result is a rope that is extremely high strength, very lightweight, and very low stretch. The 12-strand single braid construction is supple, non-rotational, and easily spliced. Endura 12 is ideally suited for wire replacement and where weight is a primary design consideration.

Features:

  • Excellent strength-to-weight ratio
  • Excellent wet/dry strength retention
  • Floats
  • Will not absorb water
  • Vinyl coated for improved abrasion resistance and color coding
  • Spliceable

 

Applications:

  • Replacement for steel cable
  • Winch lines
  • Helicopter lifting lines
  • Underground pulling lines
  • Slings
  • Tug boat tow lines

 

Colors Available:

  • Black

 

Lengths Available:

  • 600'

 

SizeWeightTensile
lbs/100'g/mlbs
 1/8" (3mm)  0.4  6.0  2,800
 3/16" (5mm)  1.0  14.9  6,100
 1/4" (6mm)  1.7  25.3  9,700
 5/16" (8mm)  2.3  34.2  13,100
 3/8" (10mm)  3.3  49.1  18,800
 7/16" (11mm)  4.0  59.5  24,000

Sunlight/UV:
Very little degradation from sunlight. Can be used outside over long term if inspected regularly.

Chemicals:
HMPE has good resistance to most minerals, organics, acids, and weak alkalines. HMPE also has excellent resistance to bleaches and other oxidizing agents and to most solvents.

Heat:
HMPE melts at 300°F with progressive strength loss above 150°F.

Dielectrics:
Good resistance to the passage of electrical current. However, dirt, surface contaminants, water entrapment, and the like can significantly affect dielectric properties. Extreme caution should be exercised any time a rope is in the proximity of live circuits.

Sheaves:
Recommended sheave diameter to rope diameter is 8:1.

Working Loads:
No blanket safe working load (SWL) recommendations can be made for any line because SWL's must be calculated based on application, conditions of use, and potential danger to personnel among other considerations. It is recommended that the end user establish working loads and safety factors based on best practices established by the end user's industry; by professional judgment and personal experience; and after thorough assessment of all risks. The SWL is a guideline for the use of a rope in good condition for non-critical applications and should be reduced where life, limb, or valuable property is involved, or in cases of exceptional service such as shock loading, sustained loading, severe vibration, etc. The Cordage Institute specifies that the SWL of a rope shall be determined by dividing the Minimum Tensile Strength of the rope by a safety factor. The safety factor ranges from 5 to 12 for non-critical uses and is typically set at 15 for life lines

Let's See What We Have Here
There are no products to list in this category.
Product Categories
Theatre Rope-Dbl. Braid-Twisted-Glazed & Unglazed Tie Line->
Information
Terms & Conditions
Shipping & Returns
Privacy Statement
Safety Warnings